Cold chain / reefer checks

Refrigerated Trailer (Reefer) Check Form Template for Cold-chain Transport

Check the fridge unit, set point and box temperature, door seals and running gear before a chilled or frozen load leaves the yard. Each item is OK, Minor defect or Major — out of service, with a note and photo for anything wrong.

In the builder, open Templates and load this form to get started.

For Logistics & transport · Driver daily inspection pack

Why this online form template matters

A refrigerated load is only as good as the trailer carrying it. A fridge unit low on fuel, a torn door seal or a blocked air chute can spoil a full load of chilled or frozen product, and the first sign is often a rejected delivery. Cold-chain customers increasingly ask for proof that the trailer was checked and at temperature before it left.

FormSafely’s refrigerated trailer check form template records the trailer unit number, the truck number, the truck odometer, the set point and the actual box temperature reading. It then walks the driver through the fridge unit (running with no alarms, fuel level, temperature recorder), the box (door seals and curtains, doors closing and locking, floor and drain holes, airflow) and the running gear (tyres, lights, coupling, air and electrical lines).

Each item uses the same three big buttons — OK, Minor defect or Major — out of service. A defect asks what is wrong and offers a photo, and the form ends with a clear “load can go?” decision: go, or hold the load and call dispatch.

The form opens in Driver mode with large tap targets and a one-tap “Mark remaining checks OK”, so a careful check still takes only a couple of minutes in a cold yard.

Submissions land in Reports with defects badged and listed first. Export a PDF for the customer or a CSV of set points and readings to spot trailers that keep running warm.

Sign up or sign in, open Templates, load Refrigerated Trailer Check, adjust set points or checks for your fleet, and share the fill link with your cold-chain drivers.

What this FormSafely template covers

Fields aligned with the ready-made template in the FormSafely builder (you can customise after loading).

  • Date, check time and driver name (required)
  • Trailer unit number (required) and truck / prime mover number
  • Truck odometer (numbers only, km or miles)
  • Set point and box temperature reading (°C)
  • Fridge unit: running with no alarms, fuel level, temperature recorder working
  • Trailer box: door seals and curtains, doors close and lock, floor and drain holes, airflow
  • Running gear: tyres and wheels, lights and reflectors, coupling, air and electrical lines
  • Each check: OK / Minor defect / Major — out of service, with a defect note and optional photo
  • “Load can go?” decision, notes and driver signature

Questions about this template

Can I change the set point for frozen versus chilled loads?

Yes. The set point is a number question the driver fills in each time, so the same form works for chilled and frozen runs. You can also add a dropdown for load type in the builder.

What if the box temperature is out of range?

The driver picks “No — hold load and call dispatch” and can flag the fridge unit as a defect with a note and photo. The submission shows up in Reports with a defect badge.

Does this replace the fridge unit’s data logger?

No. It records that the driver checked the unit and the logger were working before departure. Keep your logger data as well; the form gives you a signed, time-stamped check to sit alongside it.

Can drivers fill it without signal?

Answers are kept on the phone as the driver goes, so a dropped connection does not lose the check. They need a connection when they tap Submit.

Ready to digitise this form?

Sign up or sign in, open Templates in the builder, load this template, and share a fill link. Export submissions as PDF or CSV from Reports when you need records.